HOTOTECH
+8613553813526
Products
Current Location:Home > Helmet testing machine > Rigidity Test Machine
Split case pump
ProductTitle: Rigidity Test Machine
ProductModel: HT-6021
Category: 84 *
Email: hongtu@lab-tester.com
CompanyName: HOTOTECH
Phone: +8613553813526
Fax: +86076987889150
Characteristic: Helmet Lateral Rigidity Tester is for testing the rigidity of a helmet, measure the extend of deformation after applying a certain load on a helmet;Helmet Rigidity Testing Bench;Helmet lateral rigidity tester

600-103_logo1.jpg


Helmet Lateral Rigidity Tester / Helmet stiffness testing machine/ Helmet Testing machine with ECE R22.05 testing standard

 

Purpose

It's for testing the rigidity of a helmet, measure the extend of deformation after applying a certain load on a helmet 

 

Standard 

It's according to ECE R22.05 testing standard

 

 

The Main Technical specifications
 

Product Name Helmet lateral rigidity tester/Helmet stiffness testing machine/Helmet testing machine
Testing standard ECE R22.05
Initial load 30N
Function It's used for helmet stiffness testing
Increase speed rate 20mm/min
The maximum load 630N
Control ways PLC control 
Display Touch screen
Electricity 220V 50HZ

Testing procedure

1. According to the standard requirement installation the helmet

2. Open the power

3. An initial load of 30N shall be applied

4. As 20mm/min speed rate increase 100N ,keep 2 minutes, until 630N, the distance between the plates shall be measured

5. As 20mm/min speed rate reduce 30N , the distance between the plates shall be measured

 

Products Show Testing machine.jpg

Company name:
Name:
Tel:
E-mail:
MsgContent:
Verify code:

Note: Please fill in your contact information is correct, you consult the content we will email to reply you! Thank you for your support!

Copyright © HOTOTECH GoogleSitemap